Barco Coronis 3MP Uživatelská příručka stáhnout pdf (Strana 17)

3. Display installation

WARNING: Use an arm that is approved by VESA (according to the VESA 100 mm stan-

dard).

Use an arm that can support the weight of the display. Refer to the technical speciﬁca-

tions of this display for the applicable weight.

Overview

The panel, standard attached to the tilt & swivel foot, is compatible with the VESA 100 mm standard. So

itcanbeusedwithanarmstandaccordingtotheVESA100mmstandard.

Therefore, the tilt & swivel foot must be removed from the panel.

1. Fasten the height mechanism of the foot by putting the red clip in the hole "Unlocking the height mech-

anism", page 9 .

2. Put the display face down on a clean and soft surface. Be careful not to damage the panel screen.

3. Remove the plastic cover with a ﬂathead screw driver.

4. Slide the plastic cover over the neck of the foot.

K5902060 CORONIS 3MP LED DISPLAY 10/04/2013 13

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 51 52

Žádné komentáře

Barco Coronis 3MP Uživatelská příručka Strana 17