Barco Coronis 5MP Uživatelský manuál stáhnout pdf (Strana 68)

Barco DPMS Screen Saver

68 Coronis 5MP Mammo

Stand-By or Suspend states. If the user wishes to go into the Stand-By or

Suspend states before going into the Off state, select the required

amount of time for each state.

If requested, the display will first go into Stand-By state, then into

Suspend state, and then into Off state. The properties of DPMS states are

listed in the following table:

Monitor Settings

Select the amount of time the display requires to warm-up. Since all CRT

based displays require some warm-up time before they are at full

performance, this ensures that the display is ready for use at the

beginning of the work day.

If you have a Barco Medical Display, select “Barco Quick Start.” If a non-

Barco display is being used, select the amount of time it takes your

display to warm up via the “Monitor Setting” section. Contact your

display vendor for this warm-up time.

On Barco CORONIS displays, the I-GUARD will stabilize the image within

a few seconds after the display returns to the active state so there is no

need for a warm-up time period.

Table 1:

DPMS State Power Savings

Monitor Recovery

Time

On None N/A

Stand-by Minimal Short

Suspend Substantial Longer

Off Maximum Longest

1 2 ... 63 64 65 66 67 68 69 70 71 72 73 ... 138 139

Žádné komentáře

Barco Coronis 5MP Uživatelský manuál Strana 68