Barco Coronis Fusion Uživatelská příručka stáhnout pdf (Strana 25)

Coronis Fusion 6MP 25

TO SWITCH YOUR DISPLAY ON USING THE CONTROL WHEEL:

1 Press the control wheel for approximately 2 seconds.

TO SWITCH YOUR DISPLAY TO STAND-BY USING THE CONTROL WHEEL:

1 Press the control wheel once, a small window pops-up. Press the

control wheel again to confirm.

As a result, the display will switch on or will switch to stand-by mode.

When the display is switched on, the power status indicator light is

dimmed. When the display is in stand-by mode, the power status

indicator light is orange.

Bringing up the OSD menu

The OSD menu allows you to configure different settings to make your

ORONIS FUSION 6MP display fit your needs within your working

environment. Also, you can retrieve general information about your

display and its current configuration settings through the OSD menu.

TO BRING UP THE OSD MENU USING THE KEYS:

1 If not already done so, switch on the display as previously

described.

2 Light up the keys indicator lights as previously described.

3 While the keys light up, touch the Menu/Enter key.

The power status indicator light can be enabled in the OSD

menu so that it will turn blue when the display is switched

on. Please refer to “To enable/disable the power status

indicator light:” on page 29 for detailed instructions on how

to do this.

In case of a power outage recovery, your display will always

start-up in the power mode it was in before the power

interruption (i.e. stand-by or on). This protects your display

against inadvertent image retention problems.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 83 84

Žádné komentáře

Barco Coronis Fusion Uživatelská příručka Strana 25