Barco Coronis Fusion Uživatelská příručka stáhnout pdf (Strana 45)

Coronis Fusion 6MP 45

Video input signals

ABOUT VIDEO INPUT SIGNALS

The available input signals for your display are:

TO MANUALLY SELECT A VIDEO INPUT SIGNAL:

1 Bring up the OSD main menu.

2 Navigate to the Configuration > Image Sources > (Left/Right)

Image Source menu.

3 Enter the Input Signal submenu.

4 Select one of the available input signals and confirm.

Your CORONIS FUSION 6MP display automatically detects the

connected video input signals. Manually selecting image

source video input signals is possible, but then your display’s

image source selection mode should be set to allow this.

Please refer to “Image source selection modes” on page 43

to do this.

DisplayPort 1 This input corresponds to the DisplayPort 1

connector as shown in the “Parts, controls

and connectors” section.

DVI 1 This input corresponds to the DVI 1

connector as shown in the “Parts, controls

and connectors” section.

DisplayPort 2 This input corresponds to the DisplayPort 2

connector as shown in the “Parts, controls

and connectors” section.

DVI 2 This input corresponds to the DVI 2

connector as shown in the “Parts, controls

and connectors” section.

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 83 84

Žádné komentáře

Barco Coronis Fusion Uživatelská příručka Strana 45